So I got Clearos 6.7 installed and it appears the VGA controller is the same:

00:02.0 VGA compatible controller: Intel Corporation Atom Processor D2xxx/N2xxx Integrated Graphics Controller (rev 0b) (prog-if 00 [VGA controller])
Subsystem: ASRock Incorporation Device 0be2
Flags: bus master, fast devsel, latency 0, IRQ 11
Memory at fe400000 (32-bit, non-prefetchable) [size=1M]
I/O ports at f1a0 [size=8]
Expansion ROM at <unassigned> [disabled]
Capabilities: [d0] Power Management version 2
Capabilities: [b0] Vendor Specific Information: Len=07 <?>
Capabilities: [90] MSI: Enable- Count=1/1 Maskable- 64bit-

I tried updated my bios, with high hopes. I booted the clearos 7.4 disk up, and as soon as it makes it past the selection screen I see a [0.0000] Tsc: Fast TSC calibration failed, a couple quick lines feed by after that, and the screen goes blank.
With an install on another computer, then transfer the hard drive, no video. Even if I try to switch to one of the consoles using the alt + F2-7, no signal.

I am not using UEFI currently since I figured legacy would be easy. Just not sure what I'm missing to get things working.