-
Hi Nick,
port 81 was a mistake it's 443 for https
I don't how to specify the outgoing interface in clients.conf.
There is the section:
Should I change it do eth2?
I ran OpenVPN as client-LAN connection. And yes I dosen't need the port forward from 1194 to eth3, I'll delete it.
But why is connection to server nearly unpossible if (http/https) trafic is run on eth3?
Is it possible that I can't connect to the static IP if no active outgoing trafic is on the device? -
-
OpenVPN with Multi-WAN
Hello,
I've problems to config Multi-WAN and OpenVPN.
OpenVPN connection works only if port 80/81 run on the same interface as OpenVPN.
I've tryed following configuration:
eth2 (primary) WAN slow DSL with Static-IP (I'll use for OpenVPN)
eth3 (backup) WAN LTE with Dynamic-IP (I'll use for surfing)
Destination Port Rules:
Port 80 (http) eth3
Port 81 (https) eth3
Port 1194 (OpenVPN) eth2
With this configuration, OpenVPN connection works only somethimes and only for a short time. If port 80/81 is on eth2 OpenVPN works stable.
What can i do?
Thanks in advance
Robert -
Toggle Sidebar