Good morning all
I changed my network topography from
Modem --- server --- WiFi
To
Modem --- WiFi --- server
The WiFi (Linksys velop) does the DHCP so I turned that off on clearos 7
I also changed the IP address of the lan port, then changed my mind and changed it back!)
SMB and winbind now will not start
They do not load at startup and when I press start on the services page they both say operation failed
I've had a glance at SMB.conf but this looks unchanged from when it worked
I'm stuck now with how to get this working again
Any ideas?
Matthew
I changed my network topography from
Modem --- server --- WiFi
To
Modem --- WiFi --- server
The WiFi (Linksys velop) does the DHCP so I turned that off on clearos 7
I also changed the IP address of the lan port, then changed my mind and changed it back!)
SMB and winbind now will not start
They do not load at startup and when I press start on the services page they both say operation failed
I've had a glance at SMB.conf but this looks unchanged from when it worked
I'm stuck now with how to get this working again
Any ideas?
Matthew
Share this post:
Responses (1)
-
Accepted Answer
Missed this post. Are you still having problems? If so, what do the logs say, especially /var/log/messages, and perhaps some of the logs in /var/log/samba/. Also, what do you get from:
And does "journalctl -xe" at this point give anything useful?systemctl start smb nmb
systemctl status -l smb nmb
Please login to post a reply
You will need to be logged in to be able to post a reply. Login using the form on the right or register an account if you are new here.
Register Here »