Forums

John
John
Offline
Resolved
0 votes
Hi all,

Summary:

I just installed ClearOS community edition. I would like to connect enp2s0 to my WAN and enp8s0f0 connected to a private network, how can I bridge traffic between these two interfaces? Does ClearOS provide any configuration menus for this?

More information:

I have 5 network interfaces on the ClearOS system:

enp2s0
enp8s0f0
enp8s0f1
enp9s0f0
enp9s0f1

I have enp2s0 connected to my WAN and enp8s0f0 serving a private lan with all of my computers. enp8s0f0 is also a DHCP server, which seems to be working fine, my clients are getting ip configuration and can reach each other on the private network. However, none of these systems are able to reach the Wan.

After I installing ClearOS I noticed that while they were showing up in the IP Settings GUI, only enp2s0 was enabled. The other 4 interfaces were disabled and I had to manually enable them via setting the ONBOOT setting in their respective ifcfg files.

Any tips?

Thank You,

Zugdud
Tuesday, August 23 2016, 11:01 PM
Share this post:
Responses (0)
  • There are no replies here yet.
Your Reply