Forums

Resolved
0 votes
Hi I have eth0 setup as a wan connection to the cable modem.
Is there a way of of adding second connection to it?
I was thinking of adding the vlan interface eth0.10 connect to the switch tag the lines and both lines should get the configurations from the dhcp from both providers.
It does not seem to work.
Is this completely wrong or I am not doing something correctly?
Thanks,
Friday, January 16 2015, 12:32 AM
Share this post:
Responses (3)
  • Accepted Answer

    Tuesday, December 08 2020, 03:59 PM - #Permalink
    Resolved
    0 votes
    Dudley Ali wrote:

    Philippe Eveleigh wrote:

    I could be wrong about this but I do not think you can. I believe there is no connection on cable, you join the Ethernet Network of your ISP.

    If you had a PPP (ADSL, VDSL) you would have a better chance at doing this since you actually login for that protocol, you would still need to contact your ISP to see if they allow you to connect more than once. Note this does not provide more bandwidth since that is a feature of the line not the connection.


    Thank you I will give it a look
    Dudley


    Hello Dudley,

    My answer at the time might not be correct. I have learned over time that some ISP's may allow more than one connection by monitoring the MAC addresses used; anyways for ISP’s here in Canada. If you are allowed more than one connection and notice that you are denied your allocated number. You may be required to contact your ISP to clear the MAC addresses that are not in use anymore.

    Regards
    The reply is currently minimized Show
  • Accepted Answer

    Dudley Ali
    Dudley Ali
    Offline
    Tuesday, December 08 2020, 03:56 AM - #Permalink
    Resolved
    0 votes
    Philippe Eveleigh wrote:

    I could be wrong about this but I do not think you can. I believe there is no connection on cable, you join the Ethernet Network of your ISP.

    If you had a PPP (ADSL, VDSL, png to ico) you would have a better chance at doing this since you actually login for that protocol, you would still need to contact your ISP to see if they allow you to connect more than once. Note this does not provide more bandwidth since that is a feature of the line not the connection.


    Thank you I will give it a look
    Dudley
    The reply is currently minimized Show
  • Accepted Answer

    Friday, January 16 2015, 10:42 PM - #Permalink
    Resolved
    0 votes
    Hi I have eth0 setup as a wan connection to the cable modem.
    Is there a way of of adding second connection to it?
    I was thinking of adding the vlan interface eth0.10 connect to the switch tag the lines and both lines should get the configurations from the dhcp from both providers.
    It does not seem to work.
    Is this completely wrong or I am not doing something correctly?
    Thanks,

    I could be wrong about this but I do not think you can. I believe there is no connection on cable, you join the Ethernet Network of your ISP.

    If you had a PPP (ADSL, VDSL) you would have a better chance at doing this since you actually login for that protocol, you would still need to contact your ISP to see if they allow you to connect more than once. Note this does not provide more bandwidth since that is a feature of the line not the connection.
    The reply is currently minimized Show
Your Reply